Try putting it back in AUTO and then restart. Possible causes for both codes are a dead or bad battery, bad starter or wiring to the starter, or ignition coil problems.” “ If the unit is running and shuts down, attempting to restart, clear the alarm by pressing the ENTER button twice, then press AUTO. Both codes are caused when the controller told the engine to crank, but did not get a signal back that the engine was actually turning. For code 1505 “ the RPM alarm is set when a 2 cylinder unit is cranking” and for code 1515 “ the RPM alarm is set when a single cylinder unit is cranking. If this fault arises, it usually means there are internal issues or a problem with the fuel supply. RPM Sense loss is a common fault indicated by the code 1505/1515.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |